The OPTIMAL ROF rack is designed to cope with the demanding needs of IT equipment within a data center, equipment room and network or telecommunications closet. ROF’s flexible configuration options mean that it’s easy to tailor the solution to your exact requirements. Various height, depth and width options, along with a load rating of up to 1000 kg, airflow optimization solutions and flexible cable management mean that it has never been easier to custom configure a cabinet that meets your requirements.

Cabinet Configuration Details

**Ready for A/C unit installation; recommended when cooling is planned or required; IP54 when A/C unit installed according to instructions* open side / sides results in no IP protection; side panels with perforation result in protection rating IP20 max.

General  Optimal ROF Cabinet Description

Sizes

• Height: 15, 18, 21, 24, 27, 33, 36, 42, 45, 48U
• Width: 600, 800 mm
• Depth: 600, 800, 1 000, 1 200 mm (only for 42U)

Construction

• Welded-frame design
• 1.5 & 2.0 mm sheet steel

Load rating

• Standard 300 kg (15‑33U), 400 kg (36U) and 500 kg (42‑48U) for 600, 800 and 1 000 mm deep racks
• Standard 1 000 kg for 1 200 mm deep racks
• 19" vertical extrusions
• 2 pairs of sliding 19" extrusions, adjustable from inside

IP rating

• Standard IP30
• Optionally IP54 (required for A/C unit installation) with multipoint lock only
• IP20 when perforated doors used

Colors

• Standard RAL 7035 and 9 005
• Optionally other colors

Front door

• Tinted security glass door
• Swivel handle lock assembly – single or multipoint, optionally cylinder or combination lock (other locks on request)
• Door opening angle 1 800
• Easy re‑hanging to open on right or left
• Optionally steel, vented, perforated, glass with perforation, vertically divided door

Rear panel

• Removable with module for cable entry
• Can be replaced by multiple door options

Side panels

• Removable with locks Cable entries (300×100 mm)
• Top, bottom and rear plate
• 800 mm wide racks have additional cable entries in top and bottom plate
• All cable entries covered by removable blank panels

Ventilation unit openings

• Top, bottom plate
• All ventilation unit openings covered by removable blank panels

Feet

• Adjustable feet as standard; castors, lockable castors, plinth, or plinth with filter options Adaptation
• Possibility to adapt for installation of 21" equipment (on request only for 800 mm width)
• Adaptor DP‑RE‑01 needed (ordered separately)

Other

• Racks can be installed in blocks by using DP‑DR‑UNI (ordered separately)
• GND/earthing kit included